All Activity
- Past hour
-
Engine Coolant Temperature Sensor on 2019 Vauxhall Insignia
Nick_Nuneaton replied to StuTur's topic in Vauxhall Insignia Club
Have a look on Ebay, I payed about £13 for myn. -
Engine Coolant Temperature Sensor on 2019 Vauxhall Insignia
Nick_Nuneaton replied to StuTur's topic in Vauxhall Insignia Club
I had to change my sensor on my 2013 Insignia, it was located inside the filling bottle, your might be the same, easy to fit also. hope this helps - Today
-
Nick_Nuneaton joined the community
-
Hi all, I don't have a Vauxhall, but I have a Holden. I was at the Vauxhall show at Santa Pod last year and everyone I met was very friendly and interested in the car, I hope to meet some of you at the next event. Regards JonGee
-
Jongee05 joined the community
-
jayne britton joined the community
-
Glass roof has stress fracture
jayne britton posted a topic in Vauxhall Crossland & Grandland X Club
Hi, does anyone have problems with stress fractures on the glass roof. The vauxhall garage is asking £150 just to have a look. Any advice would be appreciated. Iv tried to contact relevant people but told its an insurance job. Thanks -
Jensen360 joined the community
- Yesterday
-
tamhay25 started following windows and mirrors not working
-
hi all i have a 2007 vectra c estate my front electric windows and mirrors are not working, also the passenger side button is not working either i managed to get the windows to go down with the keyfob but i cannot get them to go back up. i have checked all fuses and none are blown i dont think it can be the switch cause i would still be able to put them up with the keyfob. i have taken the door panel off no sign of corosion and its all still greased up still looks new. any other ideas what it could be ?
-
tamhay25 joined the community
-
Sorry Howy I have no experience with caravan wiring only a simple boat trailer lighting board.
-
Michael Leese started following My vectra 1999 2ltr 16 valve LS
-
I have just changed the battery on it and when I go to start it there are no dashboard lights, I know that the battery is fine. What could be the problem. Mike
-
Michael Leese joined the community
- Last week
-
Gleedy joined the community
-
Hi, can anyone help locating a new manual glass sunroof for my 1996 corsa.
-
Hi everyone, Good to be here on my wife's behalf..I drive an old Landrover. Anyway, we've just bought a 2023 Crossland, 1.5d with 15,000 on the clock. I've read lots of reviews and so far, are quite happy with it. It obviously still has the Vauxhall warranty in place and the dealer's we bought it from. The only issue I have found is it's a little clonky on the gear change on the lower gear changes. Smooth as you like after that. Is this a common thing or is it because we're not used the clutch/gear change in this car. I used to be a driving instructor, so I can drive! Be grateful to hear your experiences on this. Thank you.
-
Toddy joined the community
-
85ash joined the community
-
Hi, I couldn’t find any info on this either but have just fitted a set of aftermarket reversing sensors (Streetwise from Aldi) I lucked out and probed the positive wire first - Grey with green stripe and any random thin black cable I only probed two though. rear light cluster connector for me (clip on left) 1 - not used 2 - rear light + 3 - ground 4 - reverse light +
-
AndyR started following Vauxfest 2025
-
Hi folks. Stonham Barns is holding Vauxfest again this year. But this year they are allowing club stands too. If anyone is interested in attending the details are to follow.
-
Set about the wheel bearing today. All sorted and I have my gauges back working g. Can't check speedo yet as battery flat. But will be checking over the brakes and then will see about booking the mot. I have a feeling the bearing had seen better days.
-
StuTur joined the community
-
Roy R started following Tow bar electrics
- Earlier
-
Failed firmware upgrade
ALISON HARVEY replied to ALISON HARVEY's topic in Vauxhall Crossland & Grandland X Club
Thanks Jay. Will make an obvious mark somewhere! -
Failed firmware upgrade
Jay21 replied to ALISON HARVEY's topic in Vauxhall Crossland & Grandland X Club
Hi Alison, I wanted to let you know that my radio arrived at the dealer on Monday, and they were able to “replace” it today. Oddly enough, it looks exactly like the same radio. The screen still has the same fingerprints from this morning. Honestly, I don’t believe they actually replaced it; when a screen is changed, you usually get a protective cover on it, which I didn't receive. In my opinion, they just disconnected and reconnected it. Since the third-party warranty is covering this, I didn’t feel it was worth questioning further. Maybe when you take your car, you could ask for the old unit back? Or make a tiny mark on one of the buttons… -
Anyone know how to reset parking sensors? On 2012 meriva
-
hello - same car and same year and same problem - did you get a resolve at all?
-
Can anyone tell me the caravan grey cable for fridge and battery charging colour of switched wires ignition off
-
Sluggish only when starting But keeps going from D1 D3D3 randomly automatic car
-
Hi I'm still looking for switched live feed colour wire for towing electrics (fridge) Also charging feed for caravan battery hope some kind person can advise. Many thanks Howy
-
Aking35 started following 2019 Grandland X Intellilink Vauxhall logo loop
-
Hi, I have a 2019 Grandland X with intellilink 4.0 that is not working. I get the Vauxhall logo looping 5 or 6 times then goes to a blue software loading screen, again about 5 or 6 times then goes off completely. I haven't bricked it in any way to affect the start up script. I have tried updating it with the latest firmware from Vauxhall, but it does not work. I can see the USB flash drive is working by its light, but the system doesn't seem to be reading it after an initial second flashing. Any ideas what this could be before I spend a small fortune replacing it. Thank you
-
Thanks anyway
-
So have had a a20dth engine go bang (oil pump seal). I went and bought another 2.0 engine to get fitted however on fitting have realised it is a A20dt/lbr... now engine loom, ecu, body control module, clocks and immobiliser chip/transponder have also been changed.. and it won't turn over or fire.. the original engine had a 3 pin crank sensor and new one has 2 pin.. however I assumed with all the ecu kit been swapped it would register for the difference.. with the original ecu kit fitted the engine turns over but won't fire due to no signal from the crank sensor..... is there something else needed or have I totally messed up with the engine codes?
-
No images available for this problem.