Jump to content

FRONTERATECH

Members
  • Posts

    61
  • Joined

  • Last visited

  • Days Won

    7

FRONTERATECH last won the day on September 19

FRONTERATECH had the most liked content!

Profile Information

  • Location
    North West
  • Car Model
    Meriva B

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

FRONTERATECH's Achievements

Enthusiast

Enthusiast (6/14)

  • Great Support Rare
  • One Month Later
  • Dedicated Rare
  • Reacting Well Rare
  • Collaborator Rare

Recent Badges

12

Reputation

  1. what you after PM me have new bonnet wing but need to know your chassis number also have complete new front end
  2. welcome to forum what size engine do you have is it petrol or diesel
  3. floor sections are avaiable at carbodypanels4u.co.uk the engine think is isuzu
  4. sounds like new pump at fault was it recon or new
  5. check for water ingress on the ABS module the expansion tank is above it sometimes leaks onto the module disconnect plug clean connector as the wires to power steering also go to ABS
  6. apprently through the radio system seen a similar post relating to having OEM ICE to get the noise through software in Body Control Module
  7. have you cleared the codes after new power steering pump fitted. traction contro, would relate to abs module in similar area
  8. power sounder under wing battery dead will bring it on has its own battery link to catalog and part number https://catcar.info/opel/?lang=en&l=bW9kZWx0eXBlPT1YMDR8fG1jb2RlPT1PUE18fGxhbmc9PUdCfHxzdD09NTB8fHN0cz09eyIxMCI6Ik1vZGVsIiwiMjAiOiJPcGVsICBUSUdSQS1CICggMjAwNCAtICkiLCIzMCI6IlAgRUxFQ1RSSUNBTCIsIjQwIjoiIDE2IEJPRFkiLCI1MCI6IjUuQU5USS1USEVGVCBXQVJOSU5HIFNZU1RFTSJ9fHxzY29kZT09UHx8c3Njb2RlPT0gMTZ8fG1uY29kZT09MjJ8fHNtbmNvZGU9PS03fHxpa2V5PT0zOQ%3D%3D
  9. Engine coolant temp sure it is located somewhere else on engine
  10. depends on engine Vauxhall recommends that drivers have their cambelt or timing belt replaced every 40,000 to 60,000 miles.
  11. looking for some myself have you checked it is glow plugs and not controller what codes you getting
  12. you need to get fault codes read to determine the fault unfortunately
  13. opcom seems to work ok if you can sort the software out and run on a laptop for basic code reading on apps look for torque light and EOBD factfile if you just want codes
  14. assume you have old pump keep hold of it you can get that reconditioned some places on web will have to get one myself to see why they fail
×
×
  • Create New...